Siemens CP 343-1 User Manual
Page 7
1 Properties / Services
B3L−7
CP 343-1 Lean for Industrial Ethernet / Manual Part B3L
Release 03/2007
C79000-G8976-C198-04
Configuration
It is possible to download the configuration data to the CP over MPI or
LAN/Industrial Ethernet. You require STEP 7 with NCM S7 for Industrial Ethernet
(NCM IE) with the following version:
Table 1-1
Version STEP 7
/ NCM IE
Functions of the CP
V5.2 or higher
The range of functions of the CP 343−1 Lean (CX00) can be
configured.
V5.4 or higher
Requirement for configuring the full functionality of the
CP 343−1 Lean (CX10 with firmware V1.0) including PROFINET
IO.
V5.4 Service Pack 2 *)
Requirement for configuring the full functionality of the
CP 343−1 Lean (CX10 with firmware V2.0) including Web
diagnostics.
*) To use the CP with V5.4 Service Pack 1, you will need to install Hotfix 2, the corresponding hardware
update and a block setup. You will find more information at the following Internet page:
Programming − Using Blocks
For some communications services, there are pre-programmed blocks (FCs/FBs)
available as the interface in your STEP 7 user program.
You will find a detailed description of these blocks in the NCM S7 for Ethernet
manuals.
Notice
We recommend that you always use the latest block versions for all module types.
You will find information on the latest block version and links to download the
current blocks in our Customer Support area on the Internet:
If you are using older block types, this recommendation only applies if you also
have the latest firmware version.
You will find further information and Internet addresses in the Preface of the
General Part of this manual.