Sennheiser WiCOS - Manual (Page 52)

Configuring the conference system
50
There are two ways to integrate the access point into the network and to
use the web server. You can
• integrate the access point into a network with static IP addresses or
• integrate the access point into a network with DHCP.
To call up the IP address settings :
̈
In the main navigation, click “ Setup ” > “ TCP/IP Settings ”.
The “ TCP/IP Settings ” overview screen appears.
To set an unique network identification of the access point:
̈
In the “ System Name ” field, type a name for your conference system.
To use a dynamic IP address – “ DHCP “:
̈
From the “ IP Address Mode ” drop-down list, select “ DHCP ”.
The access point automatically obtains its IP address from a server. In
order to be able to use this function, you need a DHCP server in your
network that automatically assigns IP addresses.
To use a static IP address – “ Static “:
̈
From the “ IP Address Mode ” drop-down list, select “ Static ”.
̈ In the “ IP Address ” field, type the desired IP address.
̈
In the “ Subnet Mask ” field, type the desired subnet mask.
̈
Click “ Save settings ”.
The settings are saved.
̈
Switch the access point off and on again (see page 29).
You can now access the web server via the new IP address.
̈
In the address box of the browser, type the new IP address of the access
point.
Make sure that this IP address is not used in your network.
̈ Note down the IP address so that you can call up the web server
again.