Sennheiser WiCOS - Manual (Page 78)

Integrating WiCOS into a wired conference system
76
̈
From the central unit’s operating menu, choose with the jog wheel ç
“ Conference ”, “ Initialise Units ” and “ Automatic Init ” one after
the other.
The text “ Please wait ” is shown on the display.
̈
When the text “ Press ENTER to Save Initialisation ” is shown on
the display, press the ENTER key † .
The configuration is saved. All connected wired conference units and
the switched-on wireless conference units that were initialized with
the access point are initialized automatically. Any previous
configuration is deleted.
Manually initializing all conference consoles with the central unit
If it is important that the conference units are assigned microphone
numbers in a certain order or if you only want to use certain wireless
conference units, we recommend choosing the manual initialization.
̈
Switch on all wireless conference units that you want to use in your
conference system (see page 31)
̈
Initialize the wireless conference units with the access point integrated
into your SDC 8200 conference and interpretation system (see
page 63).
̈
From the central unit’s operating menu, choose with the jog wheel å
“ Conference ”, “ Initialise Units ” and “ Manual Init ” one after the
other.
The red signal light rings
¶ and „Microphone active“ LED • on all wired
conference consoles flash. With all wireless conference units, the
microphone LED
0 flashes red and green and the signal light ring 2
flashes red.
Initialise Units
2 Automatic Init
Automatic Init
Please wait
Automatic Init
Press ENTER to
Save Initialisation
Initialise Units
1 Manual Init
SDC
§
¶
£
•
V
2
:
:
C CV D DV
Only the signal light rings of the conference units are flashing while
the signal light rings of the interpreter units remain dark.
Initialization of the interpreter units is via the “
Interpretation ”
menu (see the instruction manual of the SDC 8200 conference and
interpretation system).