Speco Technologies SIPSD37X - Manual (Page 20)

37X Speed Dome Camera 20/50
Preset
z Function MAX. 127 positions are programmable. The Preset number can be
assigned from 1 to 128 except 95. Preset 95 is reserved for entering
into OSD menu. Camera parameters such as White Balance, Auto
Exposure and others can be set up independently and each preset
can have its own parameter values independently from the other
persets. When setting up presets with a controller, Label should be
blank and "Camera Adjust" should be set to "GLOBAL" as the
default. To change the parameters, enter into OSD menu.
z Setting Presets Set Preset [1~128]
z Running Presets Go Preset [1~128]
z Deleting Presets To delete Presets, enter into OSD menu.
Swing
z Function This function is that the camera moves repetitively between two
preset positions at programmed speeds. When a swing function
runs, the camera moves from the preset assigned as the 1st point to
the preset assigned as the 2nd point in CW(Clockwise) direction.
Then the camera moves from the preset assigned as the 2nd point to
the preset assigned as the 1st point in CCW(Counterclockwise)
direction.
In case that the preset assigned as the 1st point and the preset
assigned as the 2nd point are same, the camera turns on its axis by
360° in CW(Clockwise) direction and then it turns back on its axis by
360° in CCW(Counterclockwise) direction. The Swing speed is
defined from 1°/sec to 180°/sec.
z Setting Swings To set Swing, enter into OSD menu.
z Running Swings Method 1) <Run Pattern> [Swing NO. + 10]
Method 2) <Go Preset> [Swing NO. + 140] ex) Run Swing 3 : <Run Pattern> [13]
ex) Run Swing 3 : <Go Preset> [143]
z Deleting Swings To delete Swings, enter into OSD menu.
1st Preset
2nd Preset
1 CW
Di
rec
tio
n
2 CCW
Di
rec
tio
n
OPERATION 3