Speco Technologies SIPSD37X - Manual (Page 40)

37X Speed Dome Camera 40/50
Pattern Setup
PATTERN SETUP
------------------------
PATTERN NO. 1
UNDEFINED
CLR PATTERN CANCEL
RUN PATTERN
<EDIT PATTERN>
BACK
EXIT
‰
Pattern Edit
EDIT PATTERN 1
------------------------
MOVE TO START POSITION
[NEAR:START /FAR:CANCEL]
EDIT PATTERN 1
[NEAR:SAVE /FAR:DELETE]
0/0/x1/N
z Pattern Number [1~4 ]
Selects a Pattern number to edit. If the
selected pattern number is not
defined, "UNDEFINED" will be
displayed under the selected pattern
number.
z Clear Pattern [CANCEL/OK]
Deletes the data of the selected pattern.
z Run Pattern Runs the Pattern for the test purposes to
check if it works properly.
z Edit Pattern Edits the selected pattern.
① With the Joystick of your controller, move the camera to
the start position with an appropriate zoom
magnafication. To start the pattern recording, press
NEAR key. To exit, press FAR key.
②
Move camera with joystick of controller or run preset
function to memorize the path (mostly curve path) in the
selected pattern. The movement by Joystick and preset
movement will be memorized in a pattern. After a
pattern is programmed, the remaining storage is
displayed in progress bar on the screen.
③ To save the data and exit, press NEAR key. To cancel
saving the data and delete the data, press FAR key.
OSD MENU 4