Sanyo HV-DX1E - Manual (Page 34)

Special Recording
34
Copying from DVD To VCR
This unit allows you to copy the contents of a DVD to a
VHS tape.
Note
If the DVD you are attempting to copy is copy protected,
you will not be able to copy the disc. It is not permitted
to copy Macrovision encoded DVDs. “COPY PRO-
TECTED DISC” appears on the TV screen.
11 Insert Disc.
Insert the disc you wish to copy in the DVD deck
and close the disc tray.
2 2 Insert VHS Tape.
Insert a blank VHS video tape into the VCR deck.
3 3 Press PLAY (H H) on the DVD deck.
The DVD will go into play mode
If the DVD disc menu appears, you may need to press
the PLAY (
H H ) manually to begin copying.
4 4 Press REC (z z) on the VCR deck.
The DVD+VCR will go into Record mode.
5 5 Stop the Copy Process.
When the DVD is finished playing, press the VCR
on the remote control and then press STOP (x) to
end the copy.
You must stop the Copy process manually when the
DVD movie ends, or the unit may replay and record
over and over again.
Recording from another video
recorder
With the DVD+VCR you can make recordings from an
external source, such as copying from another VCR or
a camcorder.
Note
In the following description, this DVD+VCR will be one
used for recording and other VCR will be used for play-
back.
11 VCR should be connected to the one of the
SCART sockets on the rear panel of your
DVD+VCR or the AV INPUT sockets on the front
panel of your DVD+VCR.
2 2 Press AV until the socket you wish to record
from is displayed.
AV1 Sound and Picture recording using the lower
EURO AV1 socket on the back of your DVD+VCR.
AV2 Sound and Picture recording using the upper
EURO AV2 socket on the back of your DVD+VCR.
AV3 Sound and Picture recording from AV INPUT
sockets on the front of your DVD+VCR.
3 3 Insert the recorded tape into VCR and a blank
tape into DVD+VCR.
4 4 To start recording, press REC (z z) on DVD+VCR
and press PLAY on VCR.
5 5 When you want to finish copying, press the
STOP (x
x) on both appliances.