Rear panel, Introduction, Remote control operation range – Sanyo HV-DX1E User Manual

Page 9: Remote control battery installation

Advertising
background image

INTRODUCTION

9

Rear Panel

AUDIO

OUT

VHS IN+OUT/DVD OUT

DVD/VHS

OUT

RF.OUT

AERIAL

VIDEO OUT

R

COAXIAL

L

DIGITAL
AUDIO OUT

DVD EXCLUSIVE OUT

EURO AV1

AUDIO/

VIDEO

EURO AV2
DECODER

Caution

Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the DVD+VCR.

COAXIAL (Digital audio out jack)

Connect to digital (coaxial) audio equipment.

AUDIO OUT (Left/Right)

Connect to an amplifier, receiver or stereo system.

AERIAL

Connect the aerial using this jack.

VIDEO OUT

Connect to a TV with video inputs.

EURO AV1 AUDIO/VIDEO (VHS IN+OUT/DVD OUT)

Connect to your TV set or another video recorder.

RF.OUT

Connect to your TV using this jack.

Mains lead
Connect to a power
source.

EURO AV2 DECODER

Connect to another video recorder.

Remote Control Operation Range

Point the remote control at the remote sensor and press
the buttons.

Distance: About 7m (23ft) from the front of the
remote sensor
Angle: About 30° in each direction of the front of the
remote sensor

Remote control battery installation

Detach the battery cover on the rear of
the remote control, and insert two R03
(size AAA) batteries with

and

aligned correctly.

Caution

Do not mix old and new batteries. Never mix different
types of batteries (standard, alkaline, etc.).

AAA

AAA

Note

The EURO AV2 socket is used for signal input only.
DECODER is shown but this DVD+VCR does not have
it.

Advertising