Standard Horizon QUANTUM GX2360S - Manual (Page 17)

Page 17 GX2360S
4.9 OPTIONAL ENHANCED RAM+ SECOND STATION MIC INSTALLATION
The QUANTUM is capable of using up to 2 Enhanced RAM+ mics to remotely
control the Radio, DSC and PA/Fog functions. In addition the QUANTUM can
operate as a full function intercom system. With 2 RAM+ mics connected the
QUANTUM or RAM+ mics can selective call each station individually or all at
one time.
1. Connect the RAM+ MIC Cable to the RAM MIC CONNECTOR on the rear
panel, then tighten the Cable Nut (See Figure 3).
2. Referring to Figure 3, make a 1.2” (30 mm) hole in the wall, then insert the
RAM+ MIC Cable into this hole. Connect the Gasket and Mount Base to the
RAM+ MIC Cable Connector using the Nut.
3. Drill the four Screw holes (approx. 2 mm) on the wall, then install the Mounting
Base to the wall using four screws.
4. Put the Rubber Cap on to the Nut. The installation is now complete.
Figure 3. Enhanced RAM+ MIC Instllation
Wall
Gasket
Mounting Bracket
RAM MIC Cable
Cap
Nut