Standard Horizon QUANTUM GX2360S - Manual (Page 42)

GX2360S Page 42
lected setting.
7. To exit this menu and return to radio operation mode
press the [16/9] key.
7.7.3 Setting up Individual Call Ringer
When a Individual call is received the radio will produce a ringing tone for 3
minutes. This selection allows the Individual Call ringer time to be changed.
1. Press and hold down the [CALL/SET(MENU)] key
until “RADIO SETUP” menu appear.
2. Turn the CHANNEL selector knob to select “DSC
SETUP” menu.
3. Press the [CALL/SET(MENU)] key, then select
“INDIV RING” with the CHANNEL selector knob.
4. Press the [CALL/SET(MENU)] key.
5. Turn the CHANNEL selector knob to select ringing
time of a Individual Call.
6. Press the [CALL/SET(MENU)] key to store the se-
lected setting.
7. To exit this menu and return to radio operation mode
press the [16/9] key.
7.7.4 Transmitting an Individual Call
This feature allows the user to contact another vessel with a DSC radio. This
feature is similar to calling a vessel on CH16 and requesting to go to another
channel.
1. Press the [CALL/SET(MENU)] key. The “DSC OP-
ERATION” menu will appear.
2. Turn the CHANNEL selector knob to select “INDI-
VIDUAL.” (To cancel, select “EXIT” with the CHAN-
NEL selector knob or press the [16/9] key.)
3. Press the [CALL/SET(MENU)] key. The transceiver
will beep, and the “Individual directory” will appear.
4. Turn the CHANNEL selector knob to select the “In-
dividual” you want to contact.
5. Press the [CALL/SET(MENU)] key to transmit the
individual DSC signal.
6. After INDIVIDUAL CALL is transmitted, the transceiver will wait 8 seconds
for the acknowledgment. If the reply signal is not received, the transceiver