Sunrise Medical Quickie P300 - Manual (Page 19)

19
930317 Rev. C
V I . G E N E R A L W A R N I N G S
U. RAMPS AT HOME & WORK
Make sure ramps meet all Building Codes for your area.
1. For your safety, have a licensed contractor build or remodel ramp to meet
all standards.
2. Note: The proper design will vary, depending on such things as: the length and height
of the ramp; the need for an intermediate platform; landing size; doors, and the direction
of swing, and; whether the ramp includes a turn or angle.
At A Minimum:
1. Open sides of ramp must have side rails to prevent your chair from going
over the edge.
2. Slope must not be steeper than one inch in height for every one foot of
slope length.
3. Ramp surface must be even, and have a non-skid surface.
4. You may need to add a section at the top or bottom to avoid a lip or drop-off.
5. Ramp must be sturdy.Add bracing if needed, so ramp does not “bow” when
you ride on it.
V. WHEELCHAIR LIFTS
Wheelchair lifts are used in vans, buses, and buildings to help you move from
one level to another.
1. Always turn off all power to your chair when you are on a lift. If you fail to
do so, you may touch the joystick by accident and cause your chair to drive
off the platform. (Be aware that a “roll-stop” at the end of the platform may
not prevent this).
2. Make sure there is not a lip or drop-off at the top or bottom of the platform.
These may cause a fall or tip-over.When in doubt, have someone help you.
3. Always secure the rider with a positioning belt to help prevent falls
during transfers.
4. Avoid moving forward if a wheel is “hung up” on the lip of the ramp. Backup,
reposition the caster for a more direct approach.And slowly try again.
▲
!