Sunrise Medical Quickie P300 - Manual (Page 31)

31
930317 Rev. C
I X . S E T - U P , A D J U S T M E N T & U S E
2. Height-Adjustment
a) Release the upper securing lever (A).
b) Set at desired height
c) Return securing lever to locked position.
d) Move armrest up or down to allow
armrest to snap into place
G. HEIGHT-ADJUSTABLE
ARMRESTS (OPTIONAL)
1. Installation
a) Slide the outer armpost into the receiver
mounted to the wheelchair frame.
b) The armrest will automatically lock
into place.
2. Removing Armrest
a) Rotate release lever to first stop and
remove the armrest.
3. Replacing Armrest
a) Slide armrest back into receiver.
b) Return release lever to locked position
against armpost
4. Height-Adjustment
a) Rotate release lever to second stop.
b) Slide armrest pad up or down to
desired height.
c) Return lever to locked position
against armpost.
d) Push arm pad until upper armpost
locks firmly into place.
5. Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer
armpost in the receiver:
a) Loosen the four bolts (9) on the sides
of the receiver.
b) With the armrest in the receiver,
squeeze the receiver to achieve the
desired fit.
c) Tighten the four bolts.
6. Adjusting Inner Armpost Fit
a) Two set screws (7) are installed in the
outer armpost (one on each side).
b) Turn the set screws in or out until the
desired fit is achieved.
Height-Adjustable Armrest Key
1. Inner Arm Post
2. Receiver
3. Release Lever, Locked Position
4. Armrest Pad
5. Transfer Bar
6. Side Panel
7. Tension Adjustment Set Screws
(Not shown)
8. Outer Arm Post
9. Receiver Adjustment Bolts
9
2
6
7
1
4
3
5
8
A