Sunrise Medical Quickie P300 - Manual (Page 38)

38
930317 Rev. C
E. JOYSTICK ASSEMBLY
The remote joystick assembly connects to a
microprocessor,which controls the chair’s
performance.The remote box consists of the
following parts:
1. Speed Control Knob:
Use this knob to adjust the maximum
speed of your chair.Turn it counter-clock-
wise to reduce speed; turn it clockwise to
increase speed.
2. Battery Charge Indicator:
• Green lights indicate that batteries are
fully charged.
• Yellow lights indicate that batteries need
recharging.
• When the lights stay in the red band,
the batteries must be recharged.
3. On/Off Button:
The on/off switch must be located so it is
accessible to the rider, but not in a position
that it may be accidently turned off while
the chair is moving.The on/off switch is
located on the rear of the joystick box
when shipped. Ask your authorized supplier
for alternate locations.
4. Joystick:
The joystick controls the direction and
speed of your chair.Turn the chair on and
move the joystick in the direction you
want to go.
• Moving the joystick from the neutral
(center) position disengages the motor
locks, allowing the chair to move.
• The chair will move faster the more
you move the joystick away from neutral.
Note:
If your speed becomes hard to manage,
release the Joystick and the chair will come to
a complete stop.
• When you release the joystick it will
return to neutral; the chair will slow to
a stop and the motor locks will reengage.
• We recommend that you switch the
chair off if you stop for any length of
time.This will conserve battery power.
Note:
Once the chair stops, switching the
chair off will not affect the motor locks.
5. Joystick Boot:
Make sure the boot is not torn or cracked
(this could allow water or moisture to
enter). If the boot is torn or cracked,
replace it as soon as you can.
X . O P E R A T I N G G U I D E
1
3
5
4
2