Sunrise Medical Quickie P300 - Manual (Page 27)

27
930317 Rev. C
I X . S E T - U P , A D J U S T M E N T & U S E
TOOLS YOU WILL NEED
1. Basic Tool Kit:
To set-up, adjust and maintain your chair you will need the following tools:
• 7/16" box and open-end wrench
• 1/2" box and open-end wrench
• 3/4" box and open-end wrench
• 5/32" Allen wrench
• 3/16" Allen wrench
• Phillips screwdriver #2
• Custom axle wrench (or a 1/2" open-end wrench)
You can obtain a multi-purpose tool kit from Sunrise, or buy the tools you
need from a hardware store.
2. Torque Wrench:
If you plan to adjust and maintain this chair yourself, Sunrise recommends that you
use a torque wrench.
Note:
The wrench must measure inch-pounds.You can buy a torque wrench and proper
sockets from a hardware store.
CHECK-OUT
Be sure this chair performs to your chosen operational settings. If it does not,
turn the chair off immediately and reprogram with the Quickie Smart Pad
Programmer. If you do not own a Quickie Smart Pad Programmer have your
supplier reprogram your wheelchair as needed. Or, you can order a Quickie
Smart Pad Programmer for your own use, from your supplier.
Note:
Repeat this procedure until the chair performs to your specifications
When properly set-up, this chair will operate smoothly. Check to see that all components
work properly. If you detect a problem, be sure to correct it before use.