Smart Technologies 2011 - Manual (Page 27)

g To pair clickers with the SMART Response receiver
1. If a class isn’t running, start Teacher Tools. See Starting Teacher Tools on page 23.
Teacher Tools appears.
2. Select Anonymous Mode, and then click Start Class.
The receiver’s Power light flashes and then turns solid green. The receiver’s Transmit light
flashes green.
3. Press the clicker's Power and Menu buttons simultaneously for two seconds.
Teacher Mode appears on the screen.
4. Using the clicker’s Up and Down buttons, select Scan & Pick, and then press Enter.
The clicker searches for available classrooms.
5. Use the clicker’s Up and Down buttons to select your class from the list, and then press
Enter.
If your connection is successful, a “Paired With RCV” message appears.
6. Use the Up and Down buttons to select Exit, or hold down the clicker’s Power button to turn
off the clicker.
7. Repeat steps 3 through 6 for the rest of your clickers.
You’re now ready to start a class and ask questions in Anonymous mode. See Asking instant
questions on the next page to ask single questions, or see Adding questions using the Insert
Question wizard on page 47 to create assessments.
Assigning clicker IDs
Before your students can connect and use their clickers, you must program each student’s clicker
with a unique clicker ID number. When your students connect to a class, SMART Response
software checks their clicker ID's against the class list to determine whether they are valid members
of the class.
If their clicker IDs aren't in the class list, the clickers don't connect.
g To program clicker IDs into the clickers
1. If the clicker is turned on, press the clicker's Power button to turn it off.
2. Press the clicker's Power and Menu buttons simultaneously.
Teacher Mode appears on the clicker’s screen.
C H A P T E R 2
Getting started
21