Smart Technologies 2011 - Manual (Page 72)

Connecting to the class
After you start a class, you can tell your students to connect to the class.
How the students connect to the class depends on SMART Response software's current mode. In
addition, you can prevent students from signing in.
Connecting in Anonymous mode
You must start a class in Anonymous mode before your students connect. See Starting a class in
Anonymous mode on page 63.
I
I M P O R T A N T
In all modes except VE mode, students must know the class name.
g To connect PE clickers in Anonymous mode
When the “SMART Response is ready to use” balloon message appears, tell your students to follow
this procedure.
1. Press the clicker's Power button for one second.
A message appears asking if you want to join the last class the clicker was connected to or find
a different class.
Students using LE clickers see a "Hello" message appears on their clicker's display.
2. Press the Enter button to join the last class.
OR
Press the Down button to select Find a class, and then press Enter.
The clicker scans for classes, and then displays a list of classes within range. Press the Up
and Down buttons to select the correct class, and then press Enter.
3. Press the Enter button to connect.
g To connect XE clickers in Anonymous mode
When the “SMART Response is ready to use” balloon message appears, tell your students to follow
this procedure.
C H A P T E R 3
Using SMART Response software
66