Sony RM-AV2000 - Manual (Page 9)

9
5
If you want to set a code for
another component, repeat Steps
3 and 4.
6
Press COMMANDER OFF.
Notes
• If you press a component code number that is
not on the table in the supplied “Component
Code Numbers”, the Commander beeps and
“NG” flashes after you press the ENTER key.
If this happens,check the component code
number, and try setting again.
• If you don’t input anything into the
Commander for over two minutes between
each step, the setup procedure will be
canceled. To set the code, you must again
press MUTING while pressing
COMMANDER OFF.
To check which code number is
set
Press the DISPLAY key. The code number
and “ENTER” appear twice.
To set a component code on the
OPTION button
Assign a component to the OPTION
button first (see page 17), and then follow
the procedure on page 8 to 9.
3
Press the Component Select
button* for the desired
component.
The selected component remains
displayed, and the 0 – 9, ENTER and
DISPLAY keys flash.
* When you set the component code of the
DVD or DBS/CBL button,press
repeatedly until the desired component is
displayed.
4
Press the double digit component
code number followed by the
ENTER key on the touch-key
display.
A beep sounds, and the code numbers
and “ENTER” appear twice.
Continued
TV
1 m 1 m
ENTER
COMMANDER
OFF
1 2 3
4 5 6
7 8
0
9
ENTER
VIDEO2
DISPLAY
TV
ENTER
1 2 3
4 5 6
7 8
0
9