Simrad Autopilot AP26 - Manual (Page 87)

Maintenance
20221586B
85
• The Installation Settings are global except for display units
and language, enabling settings to be distributed to all control
units in the system.
• The Seatrial settings are dependent on successful completion
of the Dockside settings.
4.3 Installation Menu
The Installation Menu is
presented on the autopilot
display by pressing and holding
the NAV/WIND/SETUP button
for 5 seconds.
Note ! The INSTALLATION MENU is different from the USER SETUP
MENU. Refer to the flow diagram on the next page for a
pictorial view of the Installation Menu.
Navigate through the Installation Menu as follows:
• Answer YES to a question by rotating the course knob
clockwise.
• Answer NO to a question or proceed to the next menu item by
pressing the STBD button.
• Return to the previous menu item by pressing the PORT
button.
• Change the selected item by rotating the course knob in either
direction.
• Exit the Installation Menu by pressing STBY, AUTO, or
NAV/WIND buttons.
When using the Installation Menu, refer to the diagram
"Installation Menu Flow Chart" on next page.
Note ! You may proceed through all items in the installation menu by
continuing pressing the STBD button.