Symmetricom S100 - Manual (Page 148)

140 S100 User Guide – Rev. D – June 2005
1
SyncServer S100
FCC
NOTICE AND COMPLIANCE STATEMENT
Class A
Symmetricom, Inc.
3750 Westwind Blvd.
Santa Rosa, Ca. 95403 USA
Declares that the following Model:
MODEL S100
NETWORK TIME SERVER
MODEL NO. S100
MODEL NO. S100/GPS
MODEL NO. S100/RB
MODEL NO. S100/GRB/GPS
CONFORM TO THE FOLLOWING FCC NOTICE:
This device has been tested and found to fully compliant with the limits with the FCC Part 15, Subpart B, Section
15.109 and ICES-003 Class A Limits, using the CISPR 22:1997 specifications and ANSI C63.4:1992 Test
Methods. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This device generates, uses, and can radiate radio frequency energy and, if installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful
interference to radio or television reception, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the computer and receiver.
• Connect the computer into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by the grantee of this device could void the user’s
authority to operate the equipment.
FCC Compliance Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Note: The Model XLi is compliant with the supplied standard antenna.
I declare that the equipment specified above conforms to the above Directives and Standards.
01 August 2003 Robert Mengelberg Quality Engineer
Date Name Title Signature