Symmetricom S100 - Manual (Page 27)

S100 User Guide – Rev. D – June 2005 19
2
5
3
Installing Your S100
Install the S100 in a physically secure location with strong physical access controls.
Symmetricom recommends that you read the operating environment requirements and other
specifications in
“S100 Specifications” on page 119 , before starting.
Rack Mounting
The S100 is designed for mounting in a standard 19-inch (48.26 cm) rack. It is important to
keep the fan inlet and outlet areas clear to maintain air flow. If the unit is installed in a closed
or multi-unit rack assembly, the operating ambient temperature of the rack environment may
become greater than that of the room. Be sure that the ambient temperature is no higher than
50°C/122°F. Make sure the unit is properly balanced and grounded.
Primary Power Connection
The S100 uses external AC power.
The unit has a power cable with a PH-386, IEC 320-C-13 three-conductor female connector
on the computer end of the cable. The other end of the cable has a NEMA 6-15P grounding
plug (US Standard, 15-amp, 125-volt, straight-blade plug).
Important Safety Instructions!
When using your telephone equipment, basic safety precautions should always be followed
to reduce the risk of fire, electric shock and injury to persons. Do not use this product near
water or in a damp location.
Caution: To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.
WARNING!
To prevent electrical shock or
injury, DO NOT remove the S100
cover.
Dangerous voltages exist within
this enclosure!