Configuring ntp, Irig-b (v.120,122,123) – Symmetricom S100 User Manual
Page 53
S100 User Guide – Rev. D – June 2005
45
2
5
3
There is no output to the “Mail test” field. That is because mail is tested by sending an e-mail
to the address that you indicated earlier.
Click
Finish.
Setup Complete dialog
This screen verifies your configuration of the S100:
• Its time source
• Host name
• System location
• Administrator e-mail
Configuring NTP
To configure NTP, use the NTP Relationships dialog (See
. Use the dialog to view the NTP status and create the NTP associations.
IRIG-B (v.120,122,123)
Both the D-BNC Signal Breakout Cable and the optional Rubidium oscillator cable provide a
Timecode Input connector. To use IRIG time code as a reference, connect the IRIG signal to
the Timecode Input connector, select
IRIG-B (see
), and click
Next.
If you wish to use dial-up as a backup time source to GPS, click the checkbox next to
Use
dialup for backup to IRIG-B, then the Next button.
If you do not want to back up your IRIG with dial-up, leave the checkbox unselected, and click
Next.
Figure 3-33: Your set-up is complete