Sharp DT-500 - Manual (Page 19)

18
Ceiling-mount Setup
■ It is recommended that you use the optional
Sharp ceiling-mount bracket for this installa-
tion. Before mounting the projector, contact
your nearest Sharp Authorized Service Cen-
ter or Dealer to obtain the recommended ceil-
ing-mount bracket (sold separately).
• AN-XRCM30 ceiling-mount bracket (for
U.S.A.).
• AN-60KT ceiling-mount bracket, its AN-
TK201 and AN-TK202 extension tubes (for
countries other than the U.S.A.).
■ Invert the image by setting “Ceiling + Front”
in “PRJ Mode”. See page 49 for use of this
function.
Setting up the Projector
Setting up the Projector
For optimal image quality, position the projector perpendicular to the screen with the projector’s feet
flat and level. Doing so will eliminate the need for Keystone correction and provide the best image
quality.
Side View
Standard Setup (Front Projection)
■ Place the projector at the required distance from the screen according
to the desired picture size. (See page 20.)
Example of standard setup
Screen
Lens center
H
L
• Refer to page 20 for additional information concerning “Picture (Screen) Size and Projection Dis-
tance”.
Note
DT-500_EN_f 06.2.16, 9:58 AM 18