Sharp DT-500 - Manual (Page 28)

Connections
27
Connecting to a Computer
To RGB output terminal
RGB cable
(commercially available)
When connecting a computer, ensure that it is the last device to be turned on after all the
connections are made.
Ensure that you have read the operation manuals of the devices to be connected before making
connections.
• See page 58 “Computer Compatibility Chart” for a list of computer signals compatible with the projec-
tor. Use with computer signals other than those listed may cause some of the functions to not work.
• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your near-
est Macintosh Dealer.
• Depending on the computer you are using, an image may not be projected unless the
computer’s external output port is switched on. (e.g. Press “Fn” and “F5” keys simultaneously
when using a SHARP notebook computer). Refer to the specific instructions in your computer's
operation manual to enable your computer’s external output port.
Note
To INPUT5 terminal
Supplied
accessory
Computer
DT-500_EN_g 06.2.17, 1:41 PM 27