Konica Minolta Non-Contact 3D Digitizer Range7 - Manual (Page 11)

9
Installation and Setup
n Installation
This section describes the RANGE7/5 installation procedures and precautions for installation.
<Installation procedure>
To install the RANGE7/5, you can use the following three methods:
1) Direct installation on a table or like surface (including a measuring table prepared by user)
2) Installation using tripod set (under optional accessories)
3) Installation using measuring stand set (under optional accessories)
1) Direct installation on table
The RANGE7/5 can be directly installed on a table or like surface by using the rubber soles at the bottom of the unit.
NOTE • Install the RANGE7/5 on a firm, level table.
• To install the RANGE7/5 on a table prepared by user, use a firm, level table wide enough to put to completely secure the four
rubber soles.
• When the RANGE7/5 is directly installed on a table, the RANGE7/5 may not obtain the correct measurement results depending
on the position relative to the measuring target.
In this case, use of the tripod set or measuring stand set (under optional accessories) is recommended.
2) Installation using tripod set (under optional accessories)
Mount the RANGE7/5 to the tripod platform (under optional accessories).
NOTE • Before mounting the RANGE7/5, make sure that the tripod platform is properly mounted to the tripod.
* For the tripod platform to tripod mounting procedure, refer to the instruction manual with regards to the tripod platform.
• When using the tripod set, tighten the lock lever for each part so that the tripod will not accidentally shake.
• Install the tripod set on a firm floor. To move the tripod set, slide it slowly with the dolly (under optional accessories).
[Mounting procedure]
1) Hold the tripod platform swing plate mounted to the tripod, set horizontally.
2) Hold the handles with both hands, and put the RANGE7 /5 on the swing plate.
* Among the four rubber soles at the bottom of the RANGE7 /5, the two soles
on the rear side must fit securely into the swing plate positioning holes.
3) Insert the four screws on the back of the swing plate into the platform
mounting screw holes at the bottom of the RANGE7 /5, and turn the screws
clockwise to tighten them securely.
NOTE
• When removing the RANGE7/5, perform the above procedure in the reverse
order.
• Normally, the screws at the bottom of the swing plate will not come off.
However, if the screws are forcibly turned from the RANGE7/5 removing
position, the screws may come off.