Konica Minolta Non-Contact 3D Digitizer Range7 - Manual (Page 17)

15
5) Turning power on/off
1) Push the white power button in the upper right part of the rear
panel of the RANGE7/5.
A short beep sounds, the power is switched on, and the power
button is lit yellow-green.
2) Warming-up of the RANGE7/5 starts when the laser shutter is
opened.
Memo
• RANGE7/5 needs to warm up for about 20 minutes after being
switched ON.
• While the RANGE7/5 is warming up, a message that the
RANGE7/5 is now warming up will appear on the screen of
RANGE VIEWER software. This message will disappear when
warming-up of the RANGE7/5 is completed.
3) Push the yellow-green-lit power button again. Two short beeps
will sound, the power is switched off, and then the light of the
power button will disappear.
NOTE
• Do not turn the RANGE7/5 off during measurement or data
processing after a measurement.
• When turning the power OFF, do not unplug the AC power cord
from the AC outlet until the power light disappears.
Power button