Konica Minolta Non-Contact 3D Digitizer Range7 - Manual (Page 12)

10
3) Installation using the measuring stand set (under optional accessories)
Mount the RANGE7/5 to the measuring stand platform (under optional accessories).
NOTE • Before mounting the RANGE7/5, make sure that the measuring stand platform is properly mounted to the measuring stand.
* For the procedure on how to mount the measuring stand platform to the measuring stand, refer to the instruction manual for
the measuring stand set.
• When using the measuring stand, tighten the lock lever for each part so that the measuring stand will not accidentally shake.
• Install the measuring stand on a firm floor. Do not step on the leg, or hang on the arm.
[Mounting procedure]
1) Hold the measuring stand platform swing plate horizontally mounted to
the measuring stand arm.
2) Hold the handles with both hands, and put the RANGE7/5 on the swing
plate.
* Among the four rubber soles at the bottom of the RANGE7/5, the two
soles on the rear side must securely fit into the swing plate positioning
holes.
3) Insert four screws on the back of the swing plate into the platform mounting
screw holes at the bottom of the RANGE7/5, and turn the screws clockwise
to tighten them securely.
NOTE
• When removing the RANGE7/5, perform the above procedure in the
reverse order.
• Normally, the screws at the bottom of the swing plate will not come off.
However, if the screws are forcibly turned from the RANGE7/5 removing
position, the screws may come off.