KORG KAOSS PAD KP3 - Manual (Page 17)

18
Using SD memory cards
Checking the total capacity of
the card
1. Hold down the SHIFT button and press
the PROGRAM MEMORY 1 (CARD) but-
ton.
2. Use the PROGRAM/BPM knob to select
“InFo” (card capacity).
3. Press the PROGRAM/BPM knob to
view the total capacity of the card.
Press the TAP/RANGE button (lit orange)
to return select another parameter, press
the SHIFT button to return to normal op-
eration.
Checking the remaining capacity
of the card
1. Hold down the SHIFT button and press
the PROGRAM MEMORY 1 (CARD) but-
ton.
2. Use the PROGRAM/BPM knob to select
“FrEE” (remaining card capacity).
3. Press the PROGRAM/BPM knob to
view the remaining capacity of the card.
Press the TAP/RANGE button (lit orange)
to return select another parameter, press
the SHIFT button to return to normal op-
eration.
Formatting the card
1. Hold down the SHIFT button and press
the PROGRAM MEMORY 1 button.
2. Use the PROGRAM/BPM knob to select
“ForM.”
3. Press the PROGRAM/BPM knob; the
display will indicate “NO.”
4. Use the [PROGRAM/BPM] knob to select
“yes” and press the PROGRAM/BPM knob
to format the card. When formatting is com-
plete, the display will indicate “End.”
Press the TAP/RANGE button (lit orange)
to return select another parameter, press
the SHIFT button to return to normal op-
eration.
NOTE The entire contents of the card will be lost
when you format it. If the KP3 was unable to format
the card, the display will indicate “Err” (Error).
NOTE Don’t use your computer or digital camera
to format (initialize) a card you plan to use with the
KP3. You must use the KP3 to perform the format-
ting operation. If the card was formatted on a differ-
ent device, it may not work correctly with the KP3.
Saving to card
You can save sample data, program
memory, global settings, or all settings to
the card.
1. Hold down the SHIFT button and press
the PROGRAM MEMORY 3 (SAVE) button.
2. Use the PROGRAM/BPM knob to select
the type of data you want to save.
“SMP.A” – “SMP.D”
: Sample data
“ProG” : Contents of program memory
“ALL” : All files
“GLOb” : Global setting file
3. Press the PROGRAM/BPM knob; the
file numbers available for saving will ap-
pear; 00–99 for each of the sample bank
buttons, 00–09 for all other data types.
Use the PROGRAM/BPM knob to select
the number you want to save.
“-01-”
: The selected file number is empty.
“[01]” : The selected file number (in this
case, “01”) already contains data, and will
be replaced (overwritten) with the data
you are saving now.
“[-]”
: There is an identically-named file or
folder that cannot be written.
4. Press the PROGRAM/BPM knob, then
use the PROGRAM/BPM knob to select
“yes,” and press the PROGRAM/BPM
knob to execute the Save operation. When
saving is complete, the display will indi-