Kenwood XD-A700 - Manual (Page 28)

XD-951/A900/A700 (En)
28
Preparation section
Basic section
Application section
Knowledge sections
Let’s record
1Press the play key corresponding to
the desired direction.
2Stop playback (by pressing the &
key).
To reverse the transport direction
When the equalizer or SRS 3D is applied to the sound, the sound with the applied effect can be recorded .
i
When Dolby Pro Logic, Dolby 3 Stereo or DSP mode is selected, cancel it by pressing the STEREO key of the remote control
unit.
Note that this cassette deck cannot record onto Metal tapes.
Note Note
÷ When recording is started, the tape is trans-
ported in the direction selected in this step.
÷ Wind the tape to the position where recording
is to be started.
Check the tape transport direction
indicator.
Transport direction
Recording
(Deck B only)
1. Load a tape in deck B.
1Open the door of deck B.
2Insert a tape.
3Close the door.
2. Select the tape transport direction.
3. Set the recording condition.
1Select the reverse mode.
2Select the DOLBY NR mode.
2 2
1 1
3 3
4 4
5 5
0
PUSH
OPEN
1 1
A
3 2 7
2 2
REV.MODE DOLBY NR
3 3
NR
B 00 0 0 E P A T
÷ Differentiation between normal (TYPE ) and
high (TYPE ) tape is set automatically.
÷ Remove tape slack before loading.
(Except for some areas)
÷ When the microphone is not used, set the MIC
VOL. control knob fully counterclockwise to
the minimum position.