Kenwood XD-A700 - Manual (Page 33)

XD-951/A900/A700 (En)
33
Preparation section
Basic
section
Knowledge sections
Application section
÷ If the key is pressed during playback, normal playback in order of tracks
resumes from the current track.
Playback of CD
÷ The added track number is added to the end of the existing program.
Start playback.
5
6
To quit the program mode
CD PGM
MENU
Press twice.
(at an interval of 2
sec. or more)
÷ If you are using the remote control unit, press
the key once again while “CD PGM” is dis-
played.
Remote
control unit
1 0 O 0 0 D C
1 T O 1 0 M G P
÷ When the 4 or the ¢ key is pressed during play, the program will
jump to the preceding or the following track respectively.
÷ When the 4 key is pressed once during playback, the play position
returns to the beginning of the current track being played.
÷ When the TIME key of the remote control unit is pressed during
playback, the time display appears but it soon returns to the original
display.
Check the programmed tracks (and replace, add or delete tracks as required).
4
1Select the programmed disc or track
to be replaced and press the SET
key.
2Select a disc or track to replace the
disc or track selected above (step 3-
1 and 2).
To check:
To replace a track in the program:
MULTI
CONTROL
SET
To add a track to the program:
1Select the display as shown on the
right and press the SET key.
2Perform the same operations as in
step 3-1 and 2.
To delete a track from the program:
1Select the programmed disc or track
to be cleared and press the SET key.
2Select “CLEAR” and press the SET
key.
MULTI
CONTROL
MULTI
CONTROL
MULTI
CONTROL
SET
SET
To end the above operation:
To perform an operation in step
4 after ending it, press
the CD PGM key once.
CD PGM
D3 T O 4 2 1 P
÷ The blinking item can be replaced.
D2 T 0 2 1 0 P
÷ The programmed tracks are displayed in sequence.
CL EA R 2 1 P
03 T O 4 2 1 P
D- T - - - - P
ENTER