Konica Minolta Fax Kit (FX-3) - Manual (Page 120)

6.2 Setting Up the Transmission 6
Fax Kit (FX-3) 6-31
Us
ing t
he Ut
ility
Mo
de
(F
ax
)
Ch
apt
er
6
6.2 Setting Up the Transmission
From the “TX OPERATION” menu, various functions for sending faxes can be set.
Selecting the “TX OPERATION” menu
1 Press the [Utility] key seven times.
“TX OPERATION” appears.
2 From the 10-Key Pad, press the key ([1] through [4]) for the “TX OPERATION”
function that you wish to set.
❍ The “TX OPERATION” functions are as follows:
1 SCAN CONTRAST
2 RESOLUTION
3 DEFAULT TX
4 HEADER
✎
Tip
If, at any time, you wish to quit setting a “TX OPERATION” function, press the
[No] key. When the message “STOP SETTING?” appears, press the [Yes] key
to quit.
No. TX OPERATION Characteristic/Description
1 SCAN CONTRAST This function can be used to set the default scanning contrast level to one
of five settings between “LIGHT” and “DARK”.
For dark-colored paper (media), select a setting towards “LIGHT”. For
faint or colored text, select a setting toward “DARK”.
2 RESOLUTION This function can be used to set the default scanning resolution (image
quality) to one of the following: “Standard”, “Fine”, “Super Fine”, “Half
Tone + Standard”, “Half Tone + Fine” or “Half Tone + Super Fine”.
• The manufacturer’s default setting is “Standard”.
3 DEFAULT TX This function can be used to set the default transmission mode to
“MEM.TX” or “ADF TX”.
MEM. TX: memory transmission
ADF TX: direct transmission
• The manufacturer’s default setting is “MEM.TX”.
4 HEADER This function can be used to set the default setting (“ON” or “OFF”) for
adding the header (date sent, sender’s name and fax number, etc.) when
sending faxes.
This function is not available in the United States.
• The manufacturer’s default setting is “ON”.