Konica Minolta Fax Kit (FX-3) - Manual (Page 79)

4 4.2 Reception Methods
4-28 Fax Kit (FX-3)
F
a
x T
ran
sm
is
si
on
/R
ec
ep
ti
o
n
Me
th
od
s
Ch
apte
r 4
Specifying F codes
When sending faxes
F codes can be specified when the 10-Key Pad is being used to enter the fax
number of a recipient while sending a fax.
1 Using the 10-Key Pad, enter the
fax number of the recipient.
2 Press the [ ▼] key, and then use
the 10-Key Pad to enter the SUB.
❍ A number up to 20 digits long
can be entered for the SUB.
❍ To enter an SID, continue with
step 3.
❍ If an SID will not be entered, continue with step 4.
3 Press the [
▼] key, and then use
the 10-Key Pad to enter the SID.
❍ A number up to 20 digits long
can be entered for the SID.
4 Press the [Start] key to begin scanning and sending the fax.
Programming F codes
F codes can be specified when programming one-touch dial keys or speed dial
numbers.
For details on programming F codes, refer to “Setting Up the Fax Registration” on
page 6-2 in “6 Using the Utility Mode (Fax)”.