Kenwood HM-V655MP - Manual (Page 22)

Receiving broadcast station
22 EN
To wind tape at high speed
÷ Press the STOP 7 key to stop fast winding.
÷ The same operation is also available with the 4
and ¢ keys on the main unit.
Selection of TAPE equalizer (TAPE EQ.)
When playing a tape prerecorded with Noise Re-
duction system (such as the DOLBY NR) ON, be
sure to set the "TAPE EQ." ON for playback.
Each press switches the modes as follows.
1 "TAPE EQ." ON
(TAPE equalizer is used)
2 "TAPE EQ." OFF
(TAPE equalizer is not used)
Lit when "TAPE EQ." is ON
÷ Select the "TAPE EQ." ON mode according to the
recording condition of the tape.
Selection of reverse mode
To stop playback The tape counter is set to "0000" when a cassette tape
is loaded. By writing down the counter reading in case
you want to interrupt recording (playback) in the middle
of the tape, the memo will be helpful as a reference for
locating the same position when continuing the record-
ing (playback) the next time. The tape counter figure
decreases during recording or playback of the back side
(while the
2 tape transport indicator is lit). To set the
tape counter to "0000", open the cassette holder once.
Then the counter will be reset.
A tip for use of the tape counter
1
Select "TAPE RVS".
2 Select.
3
Set it.
1 " " : (ONE-WAY)
Only one side is played back (recorded), and
then the tape stops.
2 " " : (REVERSE)
Both sides are played back (recorded), and then
the tape stops. (When the tape transport direc-
tion is " 2", the tape stops after one side has
been played (recorded)).
3 " " : (ENDLESS)
Both sides are played back endlessly. (The tape
stops after recording onto both sides. When
the tape transport direction is " 2", the tape
stops after one side has been recorded.)
(The initial setting is " "(REVERSE))
\ \ \ \
To fast wind in
direction
\
To fast wind in
direction
|
Playback of TAPE
TUNING
TAPE EQ.
STOP/
RETURN
Main unit only
5281/21-25/EN 6/13/02, 9:32 AM 22