Kenwood HM-V655MP - Manual (Page 35)

Convenient recording methods
35 EN
Desired CD tracks can be programed in the desired sequence and recorded onto a tape.
Make preparation for recording.
Be sure to put the cassette deck in stop mode.
1
Select the CD input.
2
Ensure that the "RDM" indicators are not lit.
3 Perform steps 1 to 3 of the procedure in "Recording on TAPE". §~¶
4
Insert disc in the CD player.
1
÷ If the "RDM" indicator is lit, turn it off by pressing the RANDOM key in stop mode to cancel the random play mode.
Program recording
Program the desired sequence of CD tracks.
2
Perform steps 1 and 2 of the procedure in "Lis-
tening to the desired sequence (PGM)". ª
÷ When the PGM key is pressed to cancel the edited con-
tents, the entire editing contents will be erased. ª
÷ Tracks programed beyond the available tape recording
time will be interrupted in the middle.
Start recording.
3
To interrupt a recording
(Recording and playback will be stopped)
At the end of the recording
Cassette deck : Stop is executed after an unre-
corded portion of about 4 sec. has
been produced.
÷ Recording starts from the first track in the program and
ends after having recorded the entire programed
tracks.
÷ Recording stops automatically when the program play-
back of CD has completed.
÷ When either playback or recording stops, the other op-
eration is stopped automatically.
The tape deck of the unit can record signals only on Normal (Type ) tapes. It cannot record on High (Type ) and
Metal (Type
) tapes.
If you are operating the remote, the same effect as
step 3 can be obtained by simply pressing the
O.T.E. key to start recording.
( CD-DA VIDEO CD (with PBC OFF * ) =TAPE)
5281/33-35/EN 6/19/02, 11:45 PM 35