Kenwood HM-353V - Manual (Page 47)

47
Timer operation
Application section
Reserve the timer operation.
÷ Press the remote's TIMER key repeatedly until "O.T.T."
lights up.
÷ To cancel the timer reservation after it has been activated,
press the TIMER key while the unit is ON so that all of the
timer-related indicators are turned off. (The setting made
above is still left in memory.)
÷ When the O.T.T. timer is set while the PROG.1 or
PROG.2 timer has been set, the reservation by the
PROG.1 or PROG.2 timer is canceled.
3
Put the unit in standby mode.
÷ When the unit enters the Standby mode, the
standby/timer indicator lights in green.
÷ If there is a power failure or the power cord is un-
plugged after the timer reservation has been activated,
the standby/timer indicator blinks in green. In this
case, the clock setting should be restarted from the
beginning.
4
Each press switches the timer as follows.
1 "O.T.T."
2 "PROG.
1 "
3 "PROG. 1 2 "
4 "PROG. 1 2 "
5 Extinguished
Set the time at which you want to start playback or reception (On time).
1
Adjust the time.
2
Set it.
÷ The ON time can be set in steps of 5 minutes.
÷ If you make a mistake, press the menu key and restart
from step
1.
2
To check or modify the reservation contents, restart the timer reservation from the beginning.
The time is
advanced The time is
returned
TIMER
POWER
set / demo
volume / multi control
O . T . T .
Remote control unit only