Kenwood TM-D710A - Manual (Page 25)

19
Single band mode (band A only):
Note: You can also turn the center partition bar display off {Menu No. 527}.
SElECTINg A FREQuENCy BANd
You can change the default frequency bands for bands A and B.
1 Select band A or B by pressing the [BAND SEL] control or [PF2].
2 Press [F], [BAND SEL] of your selected band.
• Each time you press [F], [BAND SEL], you cycle to the next frequency band.
• The default setting of the [ PF1 ] key also allows you to cycle to the next frequency
band.
• When masking a band, you are restricted to using only the selectable band.
• When receiving 2 signals on the same band, the image interference, sensitivity, etc.,
performance will decrease.
• Band A: 118 >> 144 (default) >> 220 >> 300 >> 430/440 (MHz).
• Band B: 144 >> 220 >> 300 >> 430/440 (default) >> 1200 (MHz).
Note:
u
M4 type models do not have the following frequency bands available:
118, 220, 300, or 1200 (MHz).
u E and M4 type models use the 430 MHz band and K type models use the 440 MHz band.
Frequency ranges:
• 118 MHz: 118 ~ 135.995 MHz • 144 MHz: 136 ~ 199.995 MHz
• 220 MHz: 200 ~ 299.995 MHz • 300 MHz: 300 ~ 399.995 MHz
• 430/440 MHz: 400 ~ 523.995 MHz
• 1200 MHz: 800 ~ 1299.990 MHz (K type: excluding cellular band)