Kenwood TM-D710A - Manual (Page 45)

39
INSTallINg The VgS-1 UNIT
Follow the instructions below to install the VGS-1 unit.
Note: The VGS-1 is sold depending upon area.
1 Remove the 8 screws from the cover of
the base unit, then remove the cover itself
from the unit.
2 From the 5 black cushions supplied with
the VGS-1, select the thickest rectangular
cushion (20 x 30 x 12 mm) and attach it to
the top surface of the VGS-1 unit.
• To prevent interference to the terminal of
the VGS-1, ensure that you attach the thick
square cushion to the base plate surface.
3 From the remaining cushions, select the
thickest square cushion (21 x 21 x 2.5
mm) and attach it to the printed circuit
board.
• The remaining cushions are not used
with this transceiver.
• Ensure that the cushion is placed within the
guidelines on the PCB.
4 Insert the VGS-1 unit into the connector
on the transceiver.
• Press down on the top of the VGS-1 unit
to ensure that it is securely attached to the
connector.
5 Replace the cover on the base unit and
secure it using the 8 screws.
cushion
connector
VGS-1
cushion
guidelines