Kenwood TM-D710A - Manual (Page 42)

36
OPTIONS
The following options are available for use with this transceiver:
• MC-45 Microphone
• MC-59 Microphone with keypad
• MCP-2A Memory Control Program
(web download software)
• MJ-88 Microphone Plug Adapter
• MJ-89 Modular Plug Microphone
Switch
• PG-2N DC Cable (2 m)
• PG-20 DC Cable (7 m)
• PG-3B Noise Filter
• PG-5A Data Cable
• PG-5G Programming Interface Cable
(2 m)
• PG-5H PC Interface Cable Kit (2 m)
• PG-5F Extension Cable Kit (4 m)
• PS-33 DC Power Supply
• PS-53 DC Power Supply
• SP-50B External Speaker
• VGS-1 Voice Guide & Storage Unit
Note: Optional accessories for use with this transceiver may change, post-production. (New
options may become available and/or current options may be discontinued.) Please refer to the
options catalog(s) for applicable transceivers.
MeMOry cONTrOl PrOgraM McP-2a
The following functions can be set only by using the MCP-2A software:
• SQC active condition
• Microphone sensitivity level
• 10 MHz mode selection
• Power on password value
Using the MCP-2A software, you can:
• View memory channel groups
• Name memory groups
• Name PM channels
• Save/load settings
• Read exported TravelPlus for Repeaters
™ files issued from the ARRL ™
(There are some version restrictions; refer to the help text of the MCP-2A.)
• Print/export memory and various settings in html
(TravelPlus for Repeaters is a trademark of ARRL.)
To download the MCP-2A software, go to:
http://www.kenwood.com/i/products/info/amateur/software_download.html
Note: This URL may change without notice.
n Using the McP-2a Software
1 Follow the directions of the installer to install the software.
2 Set up the PC COM port and baud rate.
3 The transceiver data is read from the MCP-2A software.
4 Select your desired settings, then write the data to the transceiver.