Kenmore 625.348420 User Manual
Page 5
WATER SOFTENER START-UP
SECTION 1
5
1B.
CHECK LIST OF ALL STEP-BY-STEP GUIDES TO INSTALL
Refer to the Installation Manual, part no. 7159931, for
stepĆbyĆstep guides.
To be sure you have done all the steps to install the
softener, read the following list. Page numbers
referred to are in the Installation Manual.
✔
Is the house water supply flow going into the
softener valve INLET? Trace piping to be sure.
See pages 10 and 11.
✔
Is the plumbing bypass valve (or 3 valves) set for
soft water service? See page 18.
✔
Is the valve drain hose connected to the drain fitĆ
ting the right way? Does the drain hose run to the
drain point without sharp bends or kinks that
could stop or reduce water flow? See page 16.
✔
Is the softener power cable connected to the
transformer, and is the transformer plugged into
an inside, 120VĆ60Hz electrical outlet? See page
20.
✔
Be sure to restart the water heater. See page 20.
NOTE: The state of Massachusetts requires a licensed
plumber to perform the installation.
brass
3–valve
plastic
Bypass
Valves
Water
Heater