Samsung NX-308 - Manual (Page 45)

ACCOUNT CODE (Voluntary)
Station users may enter an account code of up to seven (7) digits before hanging
up a call. This account code will appear in the last column of the SMDR for that
call record. Keyset users may enter this code using the ACC button without
interrupting a conversation. Single-line set users must temporarily interrupt the
call by hook-flashing and dialing the feature access code. If an MPD or PRS
board is installed, the Call Metering feature is activated and UNIT and COST will
print in the ACCOUNT column of the SMDR.
➥
MMC 57 CALL COST
➥
MMC 70 DIAL NUMBERING PLAN ACC: 47
➥
MMC 71 SYSTEM KEY PROGRAMMING
➥
MMC 72 STATION KEY PROGRAMMING
ALL CALL VOICE PAGE
Users can page all keysets and the external paging zone at the same time.
Keysets may be restricted from receiving pages via system programming.
➥
MMC 22 CUSTOMER ON/OFF
ATTENTION TONE
To attract attention, a brief tone precedes all page announcements or intercom
voice calls.
AUTHORIZATION CODES (Voluntary)
Authorization codes are used to validate a station user and give permission to make a
call. These voluntary four-digit codes automatically adjust the dialing station's class of
dialing service to the level assigned to the code. Certain phone numbers (such as
emergency numbers) may be dialed even if the authorization codes are not known.
Authorization table numbers are optionally printed on the SMDR.
➥
MMC 63 AUTHORIZATION CODE
➥
MMC 81 SMDR OPTION
AUTOMATIC HOLD
Station users can enable or disable automatic hold at their keysets. If this feature
is enabled, while engaged in an outside call, pressing another trunk key,
TRANSFER, CONFERENCE, PAGE or DSS, puts the current call on hold. This
is not a user-selectable option.
➥
MMC 12 STATION ON/OFF AUTO HOLD: OFF
BACKGROUND MUSIC
Keyset users may choose to hear music through their speakers by pressing the
HOLD button while On-Hook. Either of two sources may be jumper-selected on
the system base board.
➥
MMC 22 CUSTOMER ON/OFF BGM: ON
NX-SERIES HYBRID KEY SYSTEM FEATURES SECTION
3 - 2