Kodak SCIENCE 1H9659 - Manual (Page 106)

Calibration Utility for MACINTOSH
2–44 September 1997 Part No. 1H9659
Calibration Setup — Densitometer
This dialog box allows you to use values from a densitometer text table
to recompute the calibration table.
NOTE: Make sure that your densitometer is calibrated before you try to
calibrate your printer with the densitometer values.
Densitometer
The Densitometer radio buttons allow you to specify what type of density
data ( Status A or Status T) your densitometer provides. The Calibration
Utility calculates the table data using the density type that the export
module needs for the current calibration slot.
NOTE: Depending on the export module and settings, one of these
options may not be available. For example, Status A is not
available for the Kodak Digital Science t DCP 9000 Printer.
Test Print — Number of Squares
The Number of Squares menu in the Test Print box allows you to specify
the number of squares (15 or 38) in your test print.