Kodak SCIENCE 1H9659 - Manual (Page 31)

Calibration Utility for MICROSOFT WINDOWS
1–23 Part No. 1H9659 September 1997
Using an Existing Calibration Table as the Starting Point
You can follow the steps below only if you have previously created and
saved a calibration table. If you are using the Calibration Utility for the
first time, no calibration tables exist yet for use as a starting point.
The table you select to use as a starting point does not contain printer setup
information. Follow the instructions in “Selecting and Setting Up a Printer”
on page 1–18 to specify information about the printer paper and media.
1. Select the Copy Table from File: radio button in the Starting Point box.
2. Click on the Select File... button.
A file selection dialog box appears.