Kenwood TK-3202 - Manual (Page 16)

10
BASIC OPERATIONS
1 Turn the Power switch/ Volume
control clockwise to switch the
transceiver power ON.
•
A beep sounds if enabled by
your dealer.
2 Press the key programmed with
the Monitor or Squelch Off
function to hear background
noise, then rotate the Power
switch/ Volume control to adjust
the volume.
3 Rotate the Channel selector to
select your desired channel.
•
When you receive an
appropriate signal, you will
hear audio from the speaker.
4 To make a call, press and hold
the PTT switch, then speak into
the microphone using your normal
speaking voice.
•
Hold the microphone
approximately 1.5 inches
(3 to 4 cm) from your lips.
5 Release the PTT switch to
receive.
Note: When the battery pack voltage
becomes too low, transmission will stop
and an alert tone will sound. See “Low
Battery Warning” on page 19.
1
1
1