Resetting the sensors to the factory values, Appendix d-4: initial setup of sensors – Kodak 6B7198 User Manual
Page 102
Advertising
Using the Long Roll Accessory
D-38
May 2002
Appendix D-4: Initial Setup of Sensors
IMPORTANT: Do this procedure only if you installed a new sensor or if the sensor
setup was accidentally changed.
Resetting the Sensors to the Factory Values
1. Move SET/ADJ/RUN to SET.
2. Simultaneously, press and hold TEACH and MODE until nO ? appears (about
5 seconds).
NOTE: To cancel resetting the sensors to the factory values, press MODE.
3. Press TEACH until yES? appears.
4. Press MODE.
5. Move SET/ADJ/RUN to RUN.
L
D
RUN
SET
MODE
ADJ
TEACH
L
D
RUN
SET
MODE
ADJ
TEACH
L
D
RUN
SET
MODE
ADJ
TEACH
Advertising