Kodak 6B7198 - Manual (Page 24)

Connecting and Operating the Scanner
2-6 May 2002
Starting Up the Scanner System
NOTE: If the scanner’s power has been on and the scanner has been calibrated,
continue with Operating the Scanner beginning on page 2-8.
IMPORTANT: Before operating the scanner in a production environment for the
first time, validate that the scanner is working properly. See
Chapter 3, Validating the Scanner.
Placing the Empty Film Holder in the Film Holder
Guide
The empty film holder must be in place in the film holder guide when you power up
the scanner.
1. With the edge of the top handle facing the back of the scanner, center the film
holder between the two rails of the film holder guide.
2. Lower the film holder and let it gently fall into place in the scanner.
3. With your finger, apply pressure to the handle to make sure the film holder is
fully seated.
Film Holder for
HR 500 Plus Film Scanner
Film Holder for
HR Universal Film Scanner
70MM-CAL 4 x 5
P192_0020GC
70MM-CAL film holder
film holder guide
edge of handle facing back
of scanner
70 MM -C AL