Kodak 6B7198 User Manual
Page 66
Using the Long Roll Accessory
D-2
May 2002
Installing the Software for the Long Roll Accessory
1. With the PC powered off, power on the scanner.
2. Wait for the series of 3 beeps to sound at the scanner (or for the lamp to
illuminate).
You must have version 3.0 or higher of SAM (Service and Assembly Module)
diagnostic software installed on the host computer and version 3.0 or higher of
firmware on your scanner.
Downloading the Software and Firmware from
KODAK.COM
1. Go to:
http://www.kodak.com/global/en/service/software/hr500/navigation.shtml
2. If the version numbers for either the SAM diagnostic software or firmware are
higher than what is now installed on your scanner, follow the instructions on
the Web site to download the newer versions of SAM and the HR 500
firmware.
3. Follow the installation instructions on the Web site.