Konica Minolta 7235 - Manual (Page 128)

5-14. Device Configuration
119
II Network Setup - Administrators only
Chapter 5 Web Utility
Changing Device Setting
The following Device settings may be changed as noted.
„ IEEE1284 Timeout
„ USB Timeout
„ Network (Rx) Timeout
„ Network Speed
To alter any of these Device settings, follow these steps:
1
Open the Device configuration page.
2
In the Device Settings section, select the field you wish to change.
3
Enter the new settings.
4
At the bottom of the page, type in the system password in the provided field.
5
Click [Apply].
● Changes do not take effect until you start the copier. Be sure to wait at least 10 seconds after turning off
the main power switch before you turn the copier back on.