Konica Minolta 7235 - Manual (Page 179)

6-4. Scanning Documents
III Scanner
170
Chapter 6 Using the Scanner Functions
4
Press the (START) button on the control panel.
→ Real mode
All the documents on the RADF are scanned.
When scanning of all the documents is complete, the scan data is uploaded to the internet or to the
hard disk from the copier’s memory.
→ Memory mode
Memory mode is ended and the scan data is uploaded from the copier’s memory to the internet or
to the hard disk.
z The direction of the image in the data imported in with an application depends on the direction in which the document
is set on the copier.
z The document sizes that can be scanned and document setting method are the same as for copy mode. For details,
refer to the copier User’s Guide.
„ When the destination is set to [Scan to E-Mail] , [Scan to FTP] or [Scan to PC(SMB)] :
Scan data stored on the print controller's hard disk is transferred to the set destinations.
● When [Scan to E-Mail] , [Scan to FTP] or [Scan to PC(SMB)] is set as the output destination, under
some network conditions, the scanned data may be damaged. Always check that the scanned data is
not damaged.
● Printer and scanner functions cannot be performed at the same time if the optional hard disk, HD-103
Type A is not installed.
● Without HD-103 Type-A, use the scanner function only when the printer is not operated.
You cannot use the scanner function while the printer is operating.