Linn Classic Movie System - Manual (Page 10)

4
C
onnec
ting
Connecting
This chapter describes how to install your Classik Movie System and how to connect it to
speakers, TV etc.
NOTE:
In the manual ‘TV’ refers to projection TVs and monitors as well as televisions.
Unpacking
The Classik Movie System comes in a box with the following accessories:
● handset with booklet
● 2 x R6 (AA) size batteries for the handset
● AM aerial
● FM aerial
● mains lead
● this manual
We recommend that you retain all packaging in case you need to transport the Classik
Movie System at a later date.
Voltage selection
Do not connect the mains supply until you have verified that the Classik Movie
System is set to the correct voltage for your mains supply.
The Classik Movie System is factory-set for a 240 volt mains supply and must not
be connected to a mains supply other than this before it is adjusted for your
local voltage. To set the voltage, use a screwdriver to adjust the voltage selector
on the rear of the unit to the correct setting.
This appliance must be earthed. Use the earthed moulded mains lead supplied.
Never use an unearthed plug or adapter.
Positioning
You can position your Classik Movie System almost anywhere you find convenient, but
please consider the following points:
● Allow at least 10cm of space to the sides, rear and above the Classik Movie System
for air circulation.
● Never block the ventilation holes on the top and sides of the unit.
● The handset is sensitive. You should have no problems operating the Classik
Movie System with the handset wherever it is placed in a room, provided you
keep the Classik Movie System out of direct sunlight and you do not obscure the
control window.
IMPORTANT:
Do not open the Classik Movie System’s disc drawer if the unit is behind glass doors as
this can damage the drawer’s mechanism.