Linn Classic Movie System - Manual (Page 13)

7
C
onnec
ting
Connecting the Classik Movie System
Connecting the Classik Movie System to other components
For the best performance, connect the Classik Movie System to other available
components following the diagram below.
Full details on connecting the Classik Movie System are contained in this chapter.
Connecting to a mains supply
Connect the Classik Movie System to a mains supply using the mains lead provided.
IMPORTANT:
Do not turn on the mains supply until you have connected all other components.
When any connections are made to speakers or a TV, the Classik Movie System must be
configured before they will operate correctly. This is fully explained in the Setup Menus
chapter.
Once all relevant connections have been made, turn on the mains supply. The
symbol appears on the front panel display. This symbol means the unit is in standby
mode.
Connecting the aerials
Connect the supplied AM and FM aerials as shown.
Connecting to a TV (European version)
If your TV is fitted with an S-video input socket, connect as shown.
If your TV does not have an S-video input socket, connect the Classik Movie System to
the TV’s SCART socket.
NOTE:
Ensure your TV is set to accept either a Composite or S-video input. If your TV is set to
accept an RGB input, it will not display a picture from the Classik Movie System.
CLASSIK MOVIE SYSTEM
TITLE/BAND
IR SENSOR
SET-TOP BOX
VCR
CLASSIK MOVIE SYSTEM
TV
SPEAKERS
TO S VIDEO INPUT OF TV
TO SCART SOCKET OF TV