Linn Classic Movie System - Manual (Page 11)

5
C
onnec
ting
Back panel European version
IR OUT 1, 2 Infrared flasher connectors
Allow the control via the handset of auxiliary devices that accept infrared signals.
MAIN RX TX CONNECT LED indicators
Indicate signals being transmitted between units in a CONNECT system.
ACC KNEKT connector
For installing unit in a KNEKT system.
ROOM 1 - 4, MAIN IN CONNECT connectors
For linking units in a CONNECT system (see CONNECT chapter).
ROOM RX TX CONNECT LED indicators
Indicate signals being transmitted between units in a CONNECT system.
GND, AM
AM aerial connectors.
FM Aerial
FM aerial connector.
MONITOR OUT S-video output
For connection to a TV that accepts an S-video signal.
S VIDEO IN
For connection from a VCR with an S-video output.
TV SCART
For connection to the SCART socket on a TV. 10
9
8
7
6
5
4
3
2
1 Voltage selector
MAINS INPUT
Speaker output connectors
Amplified output for direct connection to speakers.
PRE OUT Line output connectors
Connections for power amplifier, and subwoofer output.
TAPE OUT, TAPE IN
For connection to a tape recorder.
AUX IN
Input from an auxiliary source.
DIGITAL OUT
For connection to a device with digital input capabilities.
VCR SCART
For connection from the SCART socket on a VCR.
The Classik Movie System should be powered down then disconnected from the
mains supply before connecting or disconnecting any of the plugs on the back
panel. If this is not done you may generate surges which could damage the
Classik Movie System or other components in your AV system.
18
17
16
15
14
13
12
11
230
-
+
1 2 4
3
5 6 7 9 8 10
18 16 15 14 13 17
12
11