Linn Classic Movie System - Manual (Page 22)

16
S
etup M
enus
FRONT POSN (position)
Calculate the approximate distance between your
seating position and your front speakers.
Highlight the 5FT/1.5M option, then use the key on
the front panel or handset to increase the distance
shown (up to 30FT/9.2M).
Select the appropriate distance by pressing ‘enter’ on
the front panel or handset.
CENTRE POSN (position)
Calculate the approximate distance between your
seating position and your centre speaker.
Highlight the 5FT/1.5M option, then use the key on
the front panel or handset to increase the distance
shown (up to 30FT/9.2M).
Select the appropriate distance by pressing ‘enter’ on
the front panel or handset.
REAR POSN (position)
Calculate the approximate distance between your
viewing position and your rear speakers.
Highlight the 5FT/1.5M option, then use the key on
the front panel or handset to increase the distance
shown (up to 30FT/9.2M).
Select the appropriate distance by pressing ‘enter’ on
the front panel or handset.
NOTES:
If you only use front speakers the above menus will not be available.
It is not necessary to add time delay to a subwoofer.
TEST TONE
When set to ON, a tone signal is sent to all speakers
(except a subwoofer) starting with the front left and
moving in a clockwise direction. The front panel
display shows all possible speakers with the
highlighted speaker indicating the current position of
the tone.
The test tone has two functions:
Testing speaker connections
If a speaker has not been connected correctly, the tone will either not be heard or will
jump to a speaker out of the clockwise sequence (meaning a speaker has been
connected to the wrong outputs on the Classik Movie System). This feature is not
available for the subwoofer.
Speaker volume trim
This feature can be used to ensure the volume level that reaches your seating position is
the same for each speaker (for subwoofer adjustment- see Subwoofer trim adjustment in
Operating Preamplifier chapter).
To perform volume trim:
● Set TEST TONE to ON. The test tone display appears on the Classik Movie System’s
front panel.
● Wait for the test tone to reach the speaker you wish to adjust.
● Repeatedly press or hold / on the handset to trim the volume as
required.* Volume trim range is -10 to +10, with neutral trim being 0.
A few seconds after the / key has been released, the test tone will continue its
clockwise direction.
* You can do this by ear or by using a Sound Pressure Level meter.